Wie können Sie Probleme bei der SPS-Integration mit anderen Fertigungssystemen beheben?

If PLC is not communicating with other manufacturing system you may check the following:- 1) check status in communication card , if Tx Rx light is glowing , also check status of card in system view or hardware configuration. 2) You may also check all the hardware devices used , like media converter’s , fo cable , patch cords etc , also you may perform OTDR to check fo cable status . 3) You can isolate both the systems and use modscan to see if data is coming from slave device . 4) Sometimes power recycling also works .

Most of the time troubleshooting PLC integration issue becomes time consuming just because of not following proper troubleshooting guidelines. -Usually there are minimum two or more applications/systems are integrated with PLC. -First step to take is observe “Error messages” on GUI or HMI this helps most of the time to understand correct issue (off course error messages should be written to the point with proper logic) -If it doesn’t work, let’s check the PLC fault logs -Then you trace the signals using different devices like multimeter. -These are traditional methods but now a days there are special software available in the market which helps to troubleshoot integration issues as well.

The most effective avenue for PLC integration testing and prove-out is to design the system in a "virtual commissioning" environment. In this hybrid implementation - software simulation together with hardware components - the PLC can operate all its functions (1) earlier in the design & commissioning cycle, (2) verify that the panels, safety components, and physical operation work together correctly, and (3) correct errors before you actually build the cell or system the PLC will control. The benefits in development time, cost, and validation are significant

Once the problem gets identified, try to find out exact root cause of the problem. Most of the time due to high production volume or TACK time there is a tendency to provide a work around and start the system this leads to future bigger problem. Based on the root cause analysis , take necessary action like replacing faulty component or caballing or for that matter any ladder logic changes. Standard practice is to follow the manufacturer's guidelines which helps not to miss any nuances.

Most of the times it happens we resolves the problem but due to urgency or pressure we tend to miss the thorough testing or verification of the solution provided. Some times it affects other working part or solution of the system or some times this may leads in to major breakdown as well. To avoid this , make a standard practice (SOP)and follow the same so that there wont be any adverse impact. Once the solution gets tested and verified, make sure it is documented in to Troubleshooting manual , Incident management tool so that it can be available for reference in future.