[en] The chemical bond parameters of Y-123, Eu-123, Pr-123 and Gd-123 compounds have calculated using the chemical bond theory of complex crystals. Their hardness have been predicted by the chemical bond definition of hardness. The calculated results indicate that the Ba-O and RE-O types of bond have a lower covalent character and the Cu-O types of bond have greater covalency. The hardness values increase as the unit cell volume of the rare earth superconductor structures decrease

[en] In this paper, we focus on a hybrid quantum computing architecture using stationary qubits inside an optical cavity and flying qubits (photons). It has been shown that direct qubit-qubit interactions for two-qubit gate implementations can be replaced by the experimentally less demanding generation of single photons on demand and linear optics photon pair measurements. The outcomes of these measurements indicate either the completion of the gate or the presence of the original qubits such that the operation can be repeated until success

[en] In situ multiphase structure Gd₆₅Mn₂₅Si₁₀ alloys were fabricated by melt spinning and subsequent crystallization treatment. In the process of crystallization, the α -Gd, GdMn₂ and Gd₅Si₃ phases precipitate in the amorphous matrix in turn. The Curie temperature ( T _C) values for the α -Gd crystallization phase and amorphous matrix can be tailored by tuning the crystallization treatment time. All three multiphase alloys obtained by crystallization treatment at 637 K for 20, 30 and 40 min, respectively, undergo multiple successive magnetic phase transitions. A table-like magnetic entropy change over a wide temperature range (∼90–120 K) and a large full width at half maximum (Δ T _FWHM) magnetic entropy change (∼230 K) were achieved in the above-mentioned crystallized alloys, resulting in large refrigerant capacities (RCs). The enhanced RCs of the three crystallized alloys for a magnetic field change of 0–5 T are in the range of 541–614 J kg⁻¹. Large Δ T _FWHM and RC values and a table-like (−Δ S _M)^max feature obtained in in situ multiphase Gd₆₅Mn₂₅Si₁₀ crystallized alloys make them suitable for potential application in efficient Ericsson-cycle magnetic refrigeration working in a temperature range from 74 to 310 K. (paper)

[en] Lyapunov-based quantum control has the advantage that it is free from the measurement-induced decoherence and it includes the instantaneous information of the system in the control. The Lyapunov control is often confronted with time delay in the control fields and difficulty in practical implementations of the control. In this paper, we study the effect of time delay on the Lyapunov control and explore the possibility of replacing the control field with a pulse train or a bang-bang signal. The efficiency of the Lyapunov control is also presented through examining the convergence time of the system. These results suggest that the Lyapunov control is robust against time delay, easy to realize and effective for high-dimensional quantum systems.

[en] Nanomechanical resonators with fundamental mode resonance frequencies in the very-high frequency (VHF), ultra-high frequency (UHF) and microwave L-band ranges are fabricated from monocystalline silicon carbide (SiC) thin film material, and measured by magnetomotive transduction, combined with a balanced-bridge readout circuit. For resonators made from the same film, we measured the frequency dependence (thus geometry dependence) of the quality factor. We have seen a steady decrease of quality factor as the frequency goes up. This indicates the importance of clamping losses in this regime. To study this source of dissipation, a free-free beam SiC nanomechanical resonator has been co-fabricated on the same chip with a doubly clamped beam resonator operating at similar frequencies. Device testing has been performed to directly compare their characteristics and performance. It is observed that a significant improvement in quality factor is attained from the free-free beam design. In addition, from studies of resonators made from different chips with varying surface roughness, we found a strong correlation between surface roughness of the SiC thin film material and the quality factor of the resonators made from it. Furthermore, we experimentally studied the eddy current damping effect in the context of magnetomotive transduction. A high-aspect ratio SiC nanowire resonator is fabricated and tested for this study. Understanding the dissipation mechanisms, and thus improving the quality factor of these resonators, is important for implementing applications promised by these devices