[en] Many active noise and vibration control systems require models of the control paths. When the controlled system changes slightly over time, adaptive digital filters for the identification of the models are useful. This paper aims at the investigation of a special class of adaptive digital filters: orthonormal filter banks possess the robust and simple adaptation of the widely applied finite impulse response (FIR) filters, but at a lower model order, which is important when considering implementation on embedded systems. However, the filter banks require prior knowledge about the resonance frequencies and damping of the structure. This knowledge can be supposed to be of limited precision, since in many practical systems, uncertainties in the structural parameters exist. In this work, a procedure using a number of training systems to find the fixed parameters for the filter banks is applied. The effect of uncertainties in the prior knowledge on the model error is examined both with a basic example and in an experiment. Furthermore, the possibilities to compensate for the imprecise prior knowledge by a higher filter order are investigated. Also comparisons with FIR filters are implemented in order to assess the possible advantages of the orthonormal filter banks. Numerical and experimental investigations show that significantly lower computational effort can be reached by the filter banks under certain conditions. (paper)

[en] The design of electrode interfaces has a strong impact on cell-based bioelectronic applications. We present a new type of microelectrode array chip featuring a nanoporous alumina interface. The chip is fabricated in a combination of top-down and bottom-up processes using state-of-the-art clean room technology and self-assembled generation of nanopores by aluminum anodization. The electrode characteristics are investigated in phosphate buffered saline as well as under cell culture conditions. We show that the modified microelectrodes exhibit decreased impedance compared to planar microelectrodes, which is caused by a nanostructuring effect of the underlying gold during anodization. The stability and biocompatibility of the device are demonstrated by measuring action potentials from cardiomyocyte-like cells growing on top of the chip. Cross sections of the cell–surface interface reveal that the cell membrane seals the nanoporous alumina layer without bending into the sub-50 nm apertures. The nanoporous microelectrode array device may be used as a platform for combining extracellular recording of cell activity with stimulating topographical cues. (paper)

[en] Devices with metallic nanoconstrictions functionalized by organic molecules are promising candidates for the role of functional devices in molecular electronics. However, at the moment little is known about transport and noise properties of nanoconstriction devices of this kind. In this paper, transport properties of bare gold and molecule-containing tunable cross-section nanoconstrictions are studied using low-frequency noise spectroscopy. Normalized noise power spectral density (PSD) S _I/I ² dependencies are analyzed for a wide range of sample resistances R from 10 Ohm to 10 MOhm. The peculiarities and physical background of the flicker noise behavior in the low-bias regime are studied. It is shown that modification of the sample surface with benzene-1,4-dithiol molecules results in a decrease of the normalized flicker noise spectral density level in the ballistic regime of sample conductance. The characteristic power dependence of normalized noise PSD as a function of system resistance is revealed. Models describing noise behavior for bare gold and BDT modified samples are developed and compared with the experimental data for three transport regimes: diffusive, ballistic and tunneling. Parameters extracted from models by fitting are used for the characterization of nanoconstriction devices. (paper)

[en] Soft nanoimprint lithography (soft NIL) relies on a mechanical deformation of a resist by a patterned polymer used as a mold. Here, we report on the investigation of the nanopattern fidelity of the high pressure imprint process based on a perfluorinated polyether (PFPE) soft mold material. The perfluorinated polyether material was found to be well suited to transfer the mold pattern into the resist by a direct imprinting process at low cost. Moderate deformations of the polymer mold structures occurring during the high pressure imprint are systematically studied. Features of decreased size are found to be more sensitive to pattern distortions. An optimized pattern design with increased structure density and constant pattern ratio is developed to minimize deformation effects. Imprints performed on the basis of these design rules result in reduced deformations and repeal their size dependence. The improved pattern transfer, especially for small structural elements, turns the direct and cost-effective soft UV-NIL into an interesting technique also for patterning tasks in the lower nanometer range.

[en] Nanostructured surfaces have recently gained in importance for electrochemical applications because of an enhanced surface area compared to planar substrates. Due to this property, structured substrates are well suited for electrochemical (bio-)sensors, capacitive coupling with electrogenic cells, and other bioelectronic applications. However, the relationship between electrolytically exposed and redox-active surface areas of nanostructured electrodes compared to planar electrodes is still under discussion. Here, we performed a series of comparative studies to elucidate processes taking place at the electrochemically active surface of gold nanopillars. The pillars, approximately 200 nm in height and 50 nm in diameter, were fabricated using template-assisted nanostructuring. The surface area increase compared to planar electrodes was determined by scanning electron microscopy (SEM), and the redox-active surface area of the same sample was derived from cyclovoltammetric studies. We found consistency between the SEM results and the electrochemically active surfaces determined by cyclic voltammetry of immobilized ferrocenylhexanethiol, immobilized cytochrome c, and oxidation/reduction of gold for small scan rates. Similar values were derived from the capacitance measured by cyclic voltammetry, whereas impedimetric measurements revealed values twice as high. Commonly used diffusion-controlled systems, such as hexacyanoferrate, showed a smaller increase of the electroactive surface area. Finally, we conclude that the sterically restricted diffusion of redox-active species leads to an inaccurate determination of the electroactive surface area of nanosized electrodes

[en] We investigated the effect of targeted gene therapy to melanoma tumours (M21) by MR-imaging. M21 and M21-L tumours were grown to a size of 850 mm³. M21 and M21-L tumours were intravenously treated with an αvβ3-integrin-ligand-coupled nanoparticle (RGDNP)/RAF(-) complex five times every 72 hours. MRI was performed at set time intervals 24h and 72h after the i.v. injection of the complex. The MRI protocol was T1-wt-SE±CM, T2-wt-FSE, DCE-MRI, Diffusion-wt-STEAM-sequence, T2-time obtained on a 1.5-T-GE-MRI device. The size of the treated M21 tumours kept nearly constant during the treatment phase (847.8±31.4 mm³ versus 904.8±44.4 mm³). The SNR value (T2-weighted images) of the tumours was 36.7±0.6 and dropped down to 30.6±1.9 (p=0.004). At the beginning the SNR value (T1-weighted images) of the tumours after contrast medium application was 42.3±1.9 and dropped down to 28.5±3.0 (p<0.001). In the treatment group the diffusion coefficient increased significantly under therapy (0.54±0.01x10^-3 mm²/s versus 0.67±0.04x10^-3 mm²/s). The DCE-MRI showed a reduction of the slope and of the Akep of 67.8±4.3 % respectively 64.8±3.3 % compared to baseline. Targeted gene delivery therapy induces significant changes in MR-imaging. MRI showed a significant reduction of contrast medium uptake parameters and increase of the diffusion coefficient of the tumours. (orig.)

[en] A plasmon-enhanced fluorescence-based antibody-aptamer biosensor — consisting of gold nanoparticles randomly immobilized onto a glass substrate via electrostatic self-assembly — is described for specific detection of proteins in whole blood. Analyte recognition is realized through a sandwich scheme with a capture bioreceptor layer of antibodies — covalently immobilized onto the gold nanoparticle surface in upright orientation and close-packed configuration by photochemical immobilization technique (PIT) — and a top bioreceptor layer of fluorescently labelled aptamers. Such a sandwich configuration warrants not only extremely high specificity, but also an ideal fluorophore-nanostructure distance (approximately 10–15 nm) for achieving strong fluorescence amplification. For a specific application, we tested the biosensor performance in a case study for the detection of malaria-related marker Plasmodium falciparum lactate dehydrogenase (PfLDH). The proposed biosensor can specifically detect PfLDH in spiked whole blood down to 10 pM (0.3 ng/mL) without any sample pretreatment. The combination of simple and scalable fabrication, potentially high-throughput analysis, and excellent sensing performance provides a new approach to biosensing with significant advantages compared to conventional fluorescence immunoassays. Graphical abstract:

[en] We investigated the luciferase activity under the control of a hsp70 promoter and MR imaging for three tumor cell lines. Three tumor cell lines, SCCVII, NIH3T3 and M21 were transfected with a plasmid containing the hsp70 promoter fragment and the luciferase reporter gene and grown in mice. Bioluminescence imaging of the tumors was performed every other day. MR imaging, pre- and post-contrast T1-wt SE, T2-wt FSE, Diffusion-wt STEAM-sequence, T2-time determination were obtained on a 1.5-T GE MRI scanner at a tumor size of 600-800 mm³ and 1400-1600 mm³. Comparing the different tumor sizes the luciferase activity of the M21 tumors increased about 149.3%, for the NIH3T3 tumors about 47.4% and for the SCCVII tumors about 155.8%. Luciferase activity of the M21 tumors (r = 0.82, p < 0.01) and the SCCVII tumors (r = 0.62, p = 0.03) correlated significant with the diffusion coefficient. In the NIH3T3 tumors the best correlation between the luciferase activity and the MRI parameter was seen for the SNR (T2) values (r = 0.78, p < 0.01). The luciferase activity per mm³ tumor tissue correlated moderate with the contrast medium uptake (r = 0.55, p = 0.01) in the M21 tumors. In the NIH3T3 and SCCVII tumors a negative correlation (r = -0.78, p < 0.01, respectively, r = -0.49, p = 0.02) was found with the T2 time. Different tissue types have different luciferase activity under the control of the same hsp70 promoter. The combination of MR imaging with bioluminescence imaging improves the characterization of tumor tissue giving better information of this tissue on the molecular level.