Precautions for the Installation of Tensile Membrane Structure

In recent years, Tensile in a variety of membrane structure is applied, film cutting, packaging process is more complex, a variety of angle changes, and processing accuracy requirements are very high, so in the production process to strengthen quality management, to ensure the production accuracy. Tensile membrane structure installation membrane structure engineering an important link, the installation of good or bad affect the length of life of the tensile membrane structure, so the installation technology is also concerned about, then you understand the installation of  tensile membrane structure needs to meet what technical requirements?

Installation requirements for the tensile structure

We should strictly follow the fixed procedures when we install the tensile membrane structure, for its installation includes three parts, one is unfolded, two is fixed, three is formed, three have a sequence, can never be reversed. Membrane structural materials compared with other building materials are still relatively fragile, and during the installation process must be operated on its surface. In order to avoid harm to it, first a safety net is required on the membrane surface, and second, the builder is required to wear softer shoes. For the installation of membrane structure to take into account the weather conditions, such as the conditions are more severe, such as the wind is larger, more rain should stop construction, wait until after bad weather and then re-run. Because of the wind is large, the membrane surface and the following pillars are prone to tremors, affecting both the construction effect and the safety of personnel. And more rain also easy to make rain water on the membrane surface accumulation. Because the membrane structure has a good pull, and different buildings need the degree of pull is not the same, so before the construction should be determined the size of the pull, and in the later construction should be strictly controlled. In addition, for our common membrane structure of some assembly work, must strictly follow the process standards, if the main connector has not been installed, it is necessary to first with a solid pressure rope fixed, so as not to shake the building.

Precautions for the processing of the tensile structure

1. the direction of the boundary: If the boundary is relatively straight, you can consider using a long edge of a membrane block as this boundary. Otherwise, this boundary can only be stitched together with the short edges of multiple membrane blocks

2. surface curvature: the previous cutting method can not give the curvature at any point of the surface.

And this software Because surface film units are used, the curvature of each cell can be obtained. If the curvature of the adjacent cell varies greatly, the surface is distorted very seriously in this position, and if the cutting seam does not cut off the restart here, the boundary of the cropped film block will have a large arc here. From the change trend of the curvature of adjacent cells, the approximate trend of the geodesic line can be judged.

3. beautiful: because the membrane material has light transmission, the actual structure can clearly see the weld, so the arrangement of cutting seams must be ruled, reasonable, it is best to form some beautiful patterns to increase the beauty of the structure. If the surface of the membrane is arranged with a pressure or ridge cable, it is best to make the cutting seam coincide with the pressure or ridge rope so that the rope does not disrupt the pattern arrangement of the weld.

4. the width of the membrane material: in the process of shape analysis of the flat mesh division, we must take into account the width of the membrane material.

Try to make the film unit contained in a film cloth as complete as possible, otherwise it will also be determined by interpolation calculation The position of the membrane block boundary point

5.the film material after inspection into the dust-removal workshop: in the feeding area, the discharge sample area, the connection area and the three areas of the connection to lay a soft plywood, to avoid direct contact with the diaphragm to the ground, to prevent wear or soiling the film. Personnel entering the workshop must wear clean clothes, change into soft slippers for workshop-specific clothing or wear socks only

6.Choose high quality stainless steel rigging products,and load rated components.

Tianjin Founder Stainless hardware, ensuring your tensile structure project has the highest quality finish, which you can rely on to perform long term.