Dong-Joo Yoon, Kyung-Hwan Lee, Jong-Geun Choi, Sangkeol Noh, Jongsang Kim
DOI: 10.4236/eng.2011.35057   PDF    HTML     4,925 Downloads   8,512 Views   Citations

Abstract

The content of biodiesel mixed with diesel fuel were compared to inspect the fuel resistance of thin resin Cr-free steel sheets, which are widely used as steel sheets of automobile fuel tank. Some additives which can be presented during the process of biodiesel preparation were added for CCT (Cyclic Corrosion Test). These additives can accelerate the occurrence of corrosion. The corrosion was appeared on the coating and painting layer and in serious cases even substrate material was corroded. For methanol, mixing with blended fuel showed the reduction in corroded area as the additive concentration was reduced in the mixed fuel. Especially the peroxide hydrogen showed the strongest corrosiveness. It is known that formic acid has a tendency of weaker corrosiveness than peroxide hydrogen, but the corrosion is occurred throughout the specimen. Water is not mixed well with fuel, and does not seem to impact on corrosion significantly. However, water is easily mixed with other additives and is considered to facilitate the corrosion by other additives.

Keywords

Fuel Resistance, Cr-Free Steel Sheet, Fuel Tank, Corrosion, Formic Acid, Peroxide Hydrogen

Share and Cite:

Conflicts of Interest

The authors declare no conflicts of interest.

References

[1]	M. G. Kang and J. H. Kim, “Biodiesel,” Auto Journal, Vol. 27, No. 2, 2005, pp. 12-19.
[2]	R. Umebayashi, N. Akao, N. Hara and K. Sugimoto, “Corrosion and Electrochemical Properties of Sn-8% Zn Alloy-Coated Steel in Methanol Containing of H2O, NaCl, and HCOOH,” Journal of The Electrochemical Society, Vol. 150, No. 7, 2003, pp. B295-B302.doi:10.1149/1.1574808
[3]	R. Umebayashi, N. Akao, N. Hara and K. Sugimoto, “Corrosion and Its Mechanism of Al-10% Si Alloy-Coated Steel in Methanol Containing of H2O, NaCl, and HCOOH,” Journal of The Electrochemical Society, Vol. 149, No. 3, 2002, pp. B75-B83.doi:10.1149/1.1447943
[4]	K. Park and J. Jung, “A Study on Corrosion Characteristics of Suspension Material by Surface Processing,” Proceedings of Korean Society of Automotive Engineering, No. 2, 2004, pp. 938-943.
[5]	J. Ryu and C. Shin, “A Study on the Properties of the Pre-sealed Steel Sheets Based on the Galvannealed Substrate for Automotive Body,” Proceedings of Korean Society of Automotive Engineering, No. 3, 2005, pp. 1956-1961.
[6]	K. Kim and J. Park, “Automotive Body Steel Corrosion and Surface Treatment,” Journal of Corros. Sci. Soc. of Korea, Vol. 20. No. 1, 1991, pp. 103-119.
[7]	Y. Miyoshi and O. Maeda, “Fundamental Research on Corrosion Resistance of Precoated Steel Sheets for Automobiles,” Trans. ISIJ, Vol. 23, 1983, pp. 974-983.
[8]	T. Tsuchiya, “Japanese Standards for Diesel Fuel Containing of 5% FAME: Investigation of Acid Generation in FAME Blended Diesel Fuels and Its Impact on Corrosion,” SAE Technical Paper, 2006-01-3303, 2006.